Lubricate Epson XP 15000 | XP series Rail Guide Part supply as ASP: Supplied as the Printer Mechanism Lubrication status when supplied as ASP: Lubricated Application Amount: Appropriate amount Grease Type: G-96 Remarks: Apply with Flux Dispenser. Lubrication Point: ( PNIK COLOR point on the above figure) Contact points on the Rail Guide Right with […]
printer
Lubricate Epson XP 15000 | XP series Frame Base
The type and amount of the grease used to lubricate the printer parts are determined based on the results of the internal evaluations. Therefore, refer to this post for the repairing procedures below, and apply the specified type and amount of the grease to the specified part of the printer mechanism. Lubricate Epson XP 15000 […]
Epson XP 15000 | XP series Maintenance Cleaning the Printhead
This is the first section of Maintenance parts. To see the other posts of Epson XP 15000,15010, 15080 Maintenance, click here – Overview: A newly structured printhead is used in this product. If any ink cartridges aren’t installed, dust or foreign material attaches easily on the printhead compared to a usual one and it may […]
Checking Epson XP-15000 | XP series Platen Gap
This section describes the procedure for checking the platen gap (PG) The standard range of the PG is as follows: • Standard: 1.2 ± 0.1 mm (PG -) This adjustment should be carried out with the mechanism in the minimum PG position (PG -) before installing the CR Scale. PG changes approximately […]
XP-15000 AdjProg initial setting and Mist Recovery check
Use the XP-15000 AdjProg Ver1.0.0, click here XP-15000 AdjProg notify Initial Setting Set the MAC Address for the Epson XP-15000, 15010, 15080 This setting is not necessary when the data in EEPROM on the Main Board can be read out. To avoid using the same MAC address which already someone uses on the same network; […]
