This section describes the procedure for checking the platen gap (PG) The standard range of the PG is as follows: • Standard: 1.2 ± 0.1 mm (PG -) This adjustment should be carried out with the mechanism in the minimum PG position (PG -) before installing the CR Scale. PG changes approximately […]
adjustment program
XP-15000 AdjProg initial setting and Mist Recovery check
Use the XP-15000 AdjProg Ver1.0.0, click here XP-15000 AdjProg notify Initial Setting Set the MAC Address for the Epson XP-15000, 15010, 15080 This setting is not necessary when the data in EEPROM on the Main Board can be read out. To avoid using the same MAC address which already someone uses on the same network; […]
Epson XP 15000 | XP series Adjustment Program Ver1.0.0 DC motors
This post will show you Epson XP-15000 Adjustment Program AdjProg Ver1.0.0 about set and measure the manufacturing variations of the DC motors: CR Motor/PF Motor/IS Motor/ASF Motor/Stacker Motor heat protection control. Also you want know about Epson XP-15000 AdjProg to reset deterioration counter, click here Or you CR Motor or ASF Motor is deterioration and […]
Epson XP-15000 Adjustment Program
Refer to the guide in the Epson XP 15000/15010/15080 Adjustment Program for the details of the procedure: Click here This section provides the operating environment, functions related to safety and privacy policy, and the adjustment item newly added of the Adjustment Program. The operating environment for the Epson XP 15000 Adjustment Program is as follows: […]
