Epson XP 15000 | XP series Adjustment Program Ver1.0.0 DC motors

This post will show you Epson XP-15000 Adjustment Program AdjProg Ver1.0.0 about set and measure the manufacturing variations of the DC motors: CR Motor/PF Motor/IS Motor/ASF Motor/Stacker Motor heat protection control.

Also you want know about Epson XP-15000 AdjProg to reset deterioration counter, click here

Or you CR Motor or ASF Motor is deterioration and need to be replaced, click here

Purpose for using the Epson XP Adjustment Program Ver1.0.0 to set or reset for these Motor heat protection control is to measure the manufacturing variations of the DC motors (CR Motor/PF Motor/IS Motor/ASF Motor/ Stacker Motor), Main Board and Power Supply Board to determine the correction value used for estimating the current values of the motors.

Look at to the picture and choose the right selection for the Epson XP 15000/15010/15080 and adjust it for the right parts

Epson XP-15000 AdjProg CR Motor heat protection control

• The notification on the XP-15000 AdjProg Ver1.0.0: ” CR Motor heat protection control”
• Caution for the step: "CR motor, mecha unit or PS board changed" while you click to the Perform button

Epson XP-15000 AdjProg PF Motor heat protection control

• The notification on the XP-15000 AdjProg Ver1.0.0: ” CR Motor heat protection control”
• Caution for the step: "PF motor, mecha unit or PS board changed"

Epson XP-15000 AdjProg IS Motor heat protection control

• The notification on the XP-15000 AdjProg Ver1.0.0: ” CR Motor heat protection control”
• Caution for the step: "I/S motor or PS board changed"

Epson XP-15000 AdjProg ASF Motor heat protection control

• The notification on the XP-15000 AdjProg Ver1.0.0: “ASF Motor heat protection control”
• Caution for the step: "ASF Motor, mecha unit, PS board or Sub board changed"

— Replace Epson XP 15000 ASF Rear, click here

Epson XP-15000 AdjProg Stacker Motor heat protection control

• The notification on the XP-15000 AdjProg Ver1.0.0: “Stacker Motor heat protection control”
• Caution for the step: "Stacker motor, PS board or Sub board changed"

Risks if the adjustment is not correctly made:

The printer cannot measure the current value of motor correctly, then the heat generation caused by motor drive cannot be estimated accurately either, and which may results in trouble such as incorrect control of motors when allotting a cool down period according to each heat generation. In the worst case, excessive heat generation may cause smoke or ignition.

The procedure for use XP-15000 AdjProg Ver1.0.0 to SOLVE these heat protection control is:

• STEP1: Select from the menu of the Adjustment Program. Check the check box of the replaced parts and press the “Perform” button to measure the correction value.
• STEP2: The correction value is automatically measured and the measurement value is written to the EEPROM on the Main Board.

One more caution when you perform these function is:

• Main board changed, but failure occur during copy EEPROM data.

That’ll about the Epson XP 15000 | XP series Adjustment Program Ver1.0.0 to measure DC motors, heat protection control

If you care about more about the Adjustment Program, go here for the support, click here

Thanks.