When interact with the printer, you can get trouble and take the message or error from them, which you don’t know. Click here to find the error and fix it yourself.
This post will show you the guide to plug and unpack the Epson XP 15000, 15010, 15080 Ink Cable, CR Motor Cable, Frame Base Assy Cable and so on.
If you get trouble with some error message on, I have told you fix them here
Epson XP-15000 15010 15080 route CR Encoder FFC
Route along the standard line, and secure at the five points with double-sided tape
Epson XP-15000 15010 15080 route CR Motor cable
Set the ferrite core into the space shown above, and route the CR Motor Cable through the two grooves on the PF Pulley Holder Assy and connect it to CN901 on the Main Board.
Epson XP-15000 15010 15080 route Housing Left Lower Assy cable
Route the PS Unit Cable and Cover Open Sensor Cable along the guide on the Lower Left Housing Assy, and secure at the five points with acetate tape.
Epson XP-15000 15010 15080 route Frame Base Left Assy cable
If you don’t know where is the Frame Base in the printer, click here and follow to catch up.
- Set the ferrite core of the Stacker Motor Cable into the space shown above on the Frame Base Left Assy.
- Route the Stacker Motor Cable and Stacker Motor Encoder Cable through the through the slit shown above on the Frame Base Left Assy, and route them through the nine hooks.
Epson XP-15000 15010 15080 route IS Encoder FFC, ASF/APG Encoder FFC
- At both side of the ASF Rear Assy, and route the FFCs while aligning their folds with the shape of the ASF Rear Assy. And then secure at the points (IS Encoder FFC: 3 points, ASF/APG Encoder FFC: 1 point) with double-sided tape.
- Route IS Encoder FFC and ASF/APG Encoder FFC along the edge on the ASF Rear Assy, and secure at the three points with double-sided tape
Epson XP-15000 15010 15080 route Waste Ink CSIC Cable
Cautions when disassembly the Epson XP-15000 Waste Ink, click here
- At right side, route at the two points shown above on the frame base with double-sided tape.
- At center, route the FFCs while aligning their folds with the shape of the Damper Holder Frame. And then secure with double-sided tape aligning with standard line.
- At left side, secure the ferrite core with double-sided tape aligning with edge of the Damper Holder Frame. And then secure the FFC at the two points shown above on the Damper Holder Frame with double-sided tape.
Epson XP-15000 15010 15080 route Rear ASF PE Sensor FFC
- Secure at the point shown above on the LD cover with double-sided tape.
- Route along the two marking on the Damper Holder Frame, and secure at the four points with double-sided tape and acetate tape
Other route and position of cable is shown in here, follow them to the details.
See you in the next posts.
