Solved Roland MDX40 Modela Error Codes
– Printer model: Roland MDX40 Modela
– Error codes on Roland MDX40 Modela model and its description:
– Roland MDX40 Modela printer Error Codes and quick guide to troubleshooting:
- Code: n01
- Display: [MODELING] LED AND [SCANNING] LED BLINK (LIMIT ERROR)
- Description: 1 Limit Sensor cable is disconnected / broken (X/Y/Z-axis) Connect the Limit Sensor cable / Replace the Limit Sensor 2 The fixing of the magnet is not correct. (X/Y/Z-axis) Replace the magnet / Re-fix the magnet 3 Wrong distance between the Limit Sensor and the magnet (X/Y/Z-axis) Adjust the distance between the Limit Sensor and the magnet
- Code: n02
- Display: [MODELING] LED BLINKS (SPINDLE ERROR)
- Description: 1 Cutting condition Explain to user User’s Manual 2 Bad contact in the cable connection to the Spindle Board Connect the cable 3 Spindle Board is broken. Replace Spindle Board 4 Bad contact in the cable connection to the Main Board Connect the cable 5 Main Board is broken Replace Main Board [3-5 MAIN BOARD REPLACEMENT] 6 Spidle Bearing is worn out Replace the Spindle Bearing [3-6 SPINDLE BEARING REPLACEMENT] 7 Life of the Spindle Unit / Cutting dusts go into the Spindle Unit Replace the Spindle Unit Referential replacement cycle of the Spindle Unit is 2000 hours.
- Code: n03
- Display: [MODELING] LED AND [VIEW] LED BLINK (COVER LIMIT ERROR)
- Description: 1 Cover Sensor cable is disconnected / Cover sensor is broken Connect the Cover Sensor cable / Replace the Cover Sensor
About Canon Servie Tool V5610
– Canon Service Tool V5610 is a tool used to perform maintenance on Canon printers and reset Canon printers after replacement of parts such as replacing ink absorbents, print heads, printer mainboard, and others. Based on the many cases we have encountered, the Service Tool is most often used to reset ink absorber counter value when the waste ink absorber is full.
– The ink absorber is going to be full of box, it has to be replaced or cleaned the waste ink absorber. Also, replaceing or cleaning the waste ink absorber, you need to repair or reset the waste ink counter value, cause those parts are concerned to each others.
– So using Canon Service Tool V5610 to reset the waste ink counter value becomes effective when the ink absorber is replaced or cleaned.
– Canon Service Tool V5610 can use to fix error code 5B00, 5B02, 5B04, 5B14, 1701, 1702, 1700 on your printer. You must enter Service Mode on your printer to use this Canon Service Tool.
– If the printer can not enter Service Mode, you can not reset it by Canon ST V5610. In this case, change EEPROM on the logic board.
Canon Service Tool V5610 Functions
– Fix Canon printer 7 times/ 8 times red light blinking:
– Fix Canon printer error code: 5B00, 5B01, 1700, 1701
Enter Service Mode on Canon Printer
1. Turn off a printer
2. Press and hold the Resume/Cancel/Stop button
3. Press and hold the ON button (do not release both buttons)
4. Release the Resume/Cancel/Stop button (do not release the ON button)
5. While holding the ON button, press the Resume/Cancel/Stop button 5 times, then release both the ON and Resume/Cancel/Stop buttons together.
– Canon printer in service mode: computer detects new hardware, led on printer goes green light.
For more information about Canon Serice Tool V5610
Contact us to get support with Roland MDX40 Modela Error case
Telegram: https://t.me/hyperaktiv
Facebook: https://www.facebook.com/dngnm/
